Gouging Electrode

SPECIFICATION
Electrode For Gouging

VJ G is designed to produce forceful arc in all positions needed for blowing gouging off the unwanted metal leaving a very smooth clean chamfered or grooved edge for further operation of welding , rebuilding or surfacing. Preparing joints to be welded , back gouging, removal of defects and unwanted sections, cutting of risers and gauges from casting. It is especially suited for cast iron, stainless steel and non-ferrous metal, which are difficult to be cut. Strike the arc by the angle less than 30o from metal and than proceed forward by pressing firmly on the metal. Hasten the manipulation speed when face gouging , back gouging and shallow should be made. If deep groove is necessary, it is better to repeat gouging operation several times with shall groove , then one final gouging operation for obtaining beautiful surface.